Get Full Version of the Exam
http://www.EnsurePass.com/200-150.html

Question No.11

Which statement about SAN zooming is true?

1. Describes can belong to more than one zone.

2. zones must be the same size.

3. zone membership can be configured only on a pWWN basis.

4. Hard zoning can be disabled

Correct Answer: A

Question No.12

Refer to the exhibit. What type of network communication is depicted?

1. 802 3 frame

2. TCP packet

3. UDP packet

4. Ethernet frame

Correct Answer: A

Question No.13

Refer to the exhibit. What two conclusions can be mode based upon the output? (Choose two.)

1. regular fromat WWNs are being used

2. the command show flogl database was run

3. the command show fcns database vsan 1 was run

4. registered name formate WWNs are being used

5. extended format WWNs are being used.

Correct Answer: BE

Question No.14

Which field in an Ethernet II frame performs the same function as the DSAP field in an 802.3 Ethernet frame?

1. Start of frame

2. EtherType

3. Frame check sequence

4. Subnetwork Access Protocol

5. Logical Link Control

Correct Answer: B

Question No.15

Which two VTP modes allow the creation of local VLANs? (Choose two.)

1. transparent

2. native

3. server

4. client

5. on

Correct Answer: AC

Question No.16

What is the minimum number of disks that are needed in RAID 1?

1. 4 disks

2. 2 disks

3. 8 disks

4. 16 disks

Correct Answer: B

Question No.17

What is the default bridge ID priority for Rapid PVST ?

A.	128
B.	32769
C.	32768
D.	4096

Correct Answer: B

Question No.18

Which two options describe what can happen when devices are in the same broadcast domain? (Choose two.)

1. They are on the same VLAN and the same switch.

2. They are on different VLANs and the same switch.

3. They are on different VLANs and different switches.

4. They are on the same VLAN and different switches.

Correct Answer: AD

Question No.19

Refer to the exhibit. You are configuring an extended access list to permit a reply from Destination Server B to Source Host A for HTTP traffic. Which extended access list should you implement on the inbound interface of Router1?

1. router(config)# permit tcp host 209.165.200.230 host 209.165.202.130 eq www

2. router(config)# permit tcp host 209.165.200.230 eq www host 209.165.202.130

3. router(config)# permit tcp host 209.165.202.130 host 209.165.200.230 eq www

4. router(config)# permit tcp host 209.165.202.130 eq www host 209.165.200.230

Correct Answer: A

Question No.20

The MAC address table on a Cisco Nexus Server switch is full .What Layer 2 network behavior will occur while the network MAC address table remains full?

1. All frames will be flooded.

2. Frames with an unknown destination address will be flooded.

3. The switch reset the Mac address table. removin all MAC addresses.

4. The stitch will remove all dynamically MAC address from the table

Correct Answer: B

Get Full Version of 200-150 Dumps